Woodstock W1814 - Manual (Page 28)

-26-
N(/(+Fne\ijDXelXcD]^%('&'/"
D
8
@EK<
E8E:
<
D8@EK
To ensure optimum power transmission from the motor
to the blade, the V-belt must be in good condition (free
from cracks, fraying and wear) and properly aligned and
tensioned (refer to the instructions on
GX^\*').
M$9\ckj
Cleaning the Model W1814 is relatively easy. Vacuum
excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built up,
use a resin dissolving cleaner to remove it.
Protect the unpainted cast iron surfaces on the table
by wiping the table clean after every use—this ensures
moisture from wood dust does not remain on bare metal
surfaces and cause rust.
Keep tables rust-free with regular applications of a quality
metal protectant.
:c\Xe`e^
For optimum performance from your machine, follow this
maintenance schedule and refer to any specific instructions
given in this section.
;X`cp:_\Zb
•
Vacuum all dust on and around the machine.
• Empty debris from the dust collection bag. DO
NOT use the jointer if debris obstructs the flow of
material into the bag. Using the jointer when the
chute is obstructed can lead to jointer malfunction
and, possibly, fire. Failure to heed this warning can
result in serious personal injury.
• Wipe down tables and all other unpainted cast iron
with a metal protectant.
Dfek_cp:_\Zb
•
Fence angle stops and cutterhead knife alignment.
• Belt tension, damage, or wear.
• Clean/vacuum dust from inside the cabinet and
around the motor.
>\e\iXc
D8B< JLI< k_Xk pfli dXZ_`e\ `j
legcl^^\[ [li`e^ Xcc dX`ek\eXeZ\ gif$
Z\[li\j@]k_`jnXie`e^`j`^efi\[#j\i`$
fljg\ijfeXc`ealipdXpfZZli%
ClYi`ZXk`fe
Since all bearings are sealed and
permanently lubricated, simply leave them
alone until they need to be replaced. DO
NOT lubricate them.