Woodstock W1814 - Manual (Page 29)

-27-
N(/(+Fne\ijDXelXcD]^%('&'/"
J
M
@:<
J
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
k\Z_$jlggfik7j_fg]fo%Y`q.
>\e\iXc
D8B< JLI< k_Xk pfli dXZ_`e\ `j
legcl^^\[ [li`e^ Xcc j\im`Z\ gifZ\$
[li\j @] k_`j nXie`e^ `j `^efi\[# j\i`$
fljg\ijfeXc`ealipdXpfZZli%
This section provides instructions for setting the fence
stops precisely at 45° inward, 90°, or 45° outward.
Efk\1Kf\ejli\XZZliXk\i\jlckjn_\e\[^\af`ek`e^#
Z_\Zbk_\XZZliXZpf]k_\j\j\kk`e^j]i\hl\ekcpdfek_cp
XkXd`e`dld n`k_XdXZ_`e`jkjZfdY`eXk`fejhlXi\Xe[
i\$X[aljkk_\d`]e\Z\jjXip%
Kfj\kk_\0'²jkfg#[fk_\j\jk\gj1
(% DISCONNECT JOINTER FROM POWER SOURCE!
)% With the fence positioned over the bed and the
sliding handle locked, loosen the fence tilting
handle.
*% Press the forward tab of the limit plate into the rear
slot of the limit block.
+% Pull the fence as far as it will go towards 90º
(perpendicular to the table), then tighten the fence
tilting handle.
Efk\1N_\epflglcck_\]\eZ\kfnXi[j0'²#`kn`cc
jkfgn_\e`k_`kjk_\c`d`kYcfZbj_X]k%
,% Use a square to check the angle of the fence, as
shown in =`^li\41.
— If the fence is perpendicular to the table, move
ahead to set the 45º stops.
— If the fence is not perpendicular to the table,
adjust the 90º stop by doing Jk\gj-$0.
J\kk`e^=\eZ\8e^c\Jkfgj
=`^li\+'% Fence stop parts identification.
=`^li\+(% Checking the 90º stop.
Limit Plate
Tab
Inward Stop
Limit Block
Rear Slot
Limit
Block Set
Screw
Jam
Nut
Limit Block
Shaft