K\jkile – Woodstock W1814 User Manual
Page 20

-18-
N(/(+Fne\ijDXelXcD]^%('&'/"
J<
K
L
G
Once the assembly is complete, test run your machine to
make sure it runs properly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review the
KiflYc\j_ffk`e^ on GX^\
**%
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
Kfk\jkilepfliaf`ek\i#[fk_\j\jk\gj1
(% Read the entire instruction manual first!
)% Make sure the cutterhead guard fully covers the
cutterhead.
*% Make sure all tools and foreign objects have been
removed from the machine.
+% Review
J<:K@FEJ(Xe[)(SAFETY and CIRCUIT
REQUIREMENTS) on
GX^\j,Æ0and connect your
machine to the power source.
,% Turn
the
jointer
FE.
— The jointer should run smoothly with little or no
vibration.
— Immediately stop the jointer if you suspect any
problems. Refer to
GX^\** to troubleshoot and
fix any problems before starting the jointer again.
-% Turn
the
jointer
F==, then remove the safety key
from the ON/OFF paddle switch.
.% Lift the paddle switch to the ON position.
— If the jointer motor does not start, then the safety
key is working properly and you have finished the
test run.
— If the jointer motor starts when the safety key is
removed, IMMEDIATELY DISCONNECT THE JOINTER
FROM THE POWER SOURCE. Refer to
GX^\**to
troubleshoot the problem.
— If you still cannot solve this or any other problem
that arises during the test run, call Tech Support.
K\jkIle
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\
Zflc[ ZXlj\ j\i`flj \p\ `ealip% N\Xi
jX]\kp ^cXjj\j [li`e^ Xjj\dYcp Xe[
fg\iXk`fe%
Cffj\ _X`i Xe[ Zcfk_`e^ Zflc[ ^\k
ZXl^_k`edXZ_`e\ipXe[ZXlj\j\i`flj
g\ijfeXc `ealip% B\\g cffj\ Zcfk_`e^
ifcc\[ lg Xe[ cfe^ _X`i k`\[ lg Xe[
XnXp]ifddXZ_`e\ip%