Sharp MD-MT888H - Manual (Page 36)

01/8/30 4.fm
36
MD-MT888H
Us
ef
ul Fea
tur
es
-Recor
d
ing f
rom a M
icr
op
hone-
Recording from a Microphone (continued)
„ Sound-actuated recording (Mic Syn-
chronised recording)
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(Pause function does not work for approximately 10 sec-
onds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
Notes:
z If the unit starts recording too often from low unwanted
noises, set the microphone input to "L(Low)".
z Recording sensitivity can be changed whilst recording.
1
Hold down the REC button for 2 seconds or
more.
You can perform the same operation by simply press-
ing the REC button on the main unit.
2
To perform group recording, hold down the
GROUP button for 1 second or more so that
"GROUP" is lit.
When group recording is not performed, hold down
the GROUP button for 1 second or more so that
"GROUP" goes out.
3
Move the M button toward or to adjust
the recording level (page 20).
The same operation can be performed by pressing
the
or button on the main unit.
4
Press the MODE button repeatedly to select
the recording mode (page 29).
5
Press the M button.
The unit enters the menu select mode.
6
Move the M button toward
or to select "M(MIC
SYNC LEVEL)" and press
it.
7
Move the M button toward or to select
the recording sensitivity and press it.
H (High): Recording starts when the unit detects -24
dB or more (the unit can start recording
from quiet sounds).
L (Low): Recording starts when the unit detects -12
dB or more.
8
Press the M button.
z The unit enters the menu select mode.
z You can perform the same operation by pressing
the SYNC button on the main unit. (At this time,
steps 9-10 can be omitted.)
9
Move the M button toward
or to select
"S(SYNC)" and press it.
10
Press the M button.
Synchro recording will be
paused.
11
When a sound, such as person speaking, is
picked up by the microphone, recording will
begin automatically.