Sharp MD-MT888H - Manual (Page 20)

01/8/30 3.fm
20
MD-MT888H
Ba
si
c O
p
er
ati
o
n
-Re
c
or
ding-
Recording (continued)
To interrupt recording
Move the M button toward .
z Recording starts by moving the M button toward
again.
z You can perform the same operation by pressing the
button on the main unit.
z The track number will be increased by one each time
the recording is interrupted.
To stop recording
Move the M button toward .
z You can perform the same operation by pressing the
button on the main unit.
z When recording stops, "TOC" appears. Whilst "TOC"
appears, the MiniDisc recorded contents have not yet
been updated.
z To prevent the new recording from being lost, it is not
possible to remove the MiniDisc whilst "TOC" is dis-
played.
To update the recorded contents of the
MiniDisc
Whilst in the stop mode, move the M button toward .
You can perform the same operation by pressing the
button on the main unit.
z The power turns off after recorded contents have been
updated on the MiniDisc.
„ Recording level
Analogue recording
Adjust the recording level so that the maximum sound
volume from the source makes the reading swing some-
where between -4 dB and 0 dB.
You can check the level on the LCD of the main unit.
Digital recording
You can adjust the level in 1dB increments within the
range of +12 - -12dB.
You can check the level on the LCD of the remote control.
Once you adjust the digital recording level, the setting is
retained even after the recording stops. (For cancellation
instructions, see page 52.)