Sharp XG-C60X - Manual (Page 31)

Connections and Setup
-27
90 °
90 °
Example of Standard Setup
Setting up the Screen
Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
Note
•
The projector lens should be centered in the middle of the screen. If the horizontal line passing through the
lens center is not perpendicular to the screen, the image will be distorted, making viewing difficult.
•
For optimal image, position the screen so that it is not in direct sunlight or room light. Light falling directly on
the screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when
setting up the screen in a sunny or bright room.
•
A polarizing screen cannot be used with this projector.
Three optional lenses from Sharp are also available for specialized application. Contact your local Sharp Authorized
Projector Dealer for details on the lens. (Refer to the lens installation manual when attaching a lens.)
Throw Distance
■ The graph below is for 100 inches (254 cm) screen with 4:3 normal mode.
Side View
Top View
• The distance from the screen to the projector
may vary depending on the size of the screen.
P.28
• The default setting can be used, when placing the
projector in front of the screen. If the projected im-
age is reversed or inverted, readjust the setting to
“Front” in “PRJ Mode”.
P.71
•
Place the projector so that an imaginary horizontal
line that passes through the center of the lens is
perpendicular to the screen.
Audience
Standard Setup (Front Projection)
■ Place the projector at the required distance from the screen
according to the desired picture size. (See page 28 .)
Screen
5 10 15 20 25 30 35 40 (ft)
AN-C41MZ
27' – 38'1'' (8.2 – 11.6m)
Throw ratio 1:4.1 – 5.8
AN-C27MZ
17'9" – 28'1'' (5.4 – 8.6m)
Throw ratio 1:2.7 – 4.3
AN-C12MZ
7'11" – 10' (2.4 – 3.0m)
Throw ratio 1:1.18 – 1.48
Standard
11'11" – 15'4" (3.6 – 4.7m)
Throw ratio 1:1.77 – 2.25
XG-C60X_E_PDF_p25_32.p65 03.8.28, 2:07 PM 27