Sony CMT-DC500MD - Manual (Page 20)

20
Notes
• You cannot pause recording during CD-MD High-
Speed Synchro Recording.
• If the play mode is set to the Repeat or Shuffle Play,
it automatically switches to normal play at step 3 of
“Recording a CD on an MD”.
• The following items are either inoperative or cannot
be used during CD-MD High-Speed Synchro
Recording:
— Auto Cut function.
— Recorded signal monitoring.
Recording a CD on an MD and
a tape at the same time
Load the CD you want to record. Then load a
blank tape and recordable MD. Press
SYNCHRO REC repeatedly until “DUAL
SYNC” appears, and then perform step 4
through 6 of “Recording a CD on a tape” (see
page 40).
Recording a tape on an
MD
— TAPE-MD Synchro Recording
You can make an analog recording of a tape on
an MD.
You can use Type I (normal) tape.
1
Load a recordable MD.
2
Load a tape.
3
Press SYNCHRO REC repeatedly until
“TAPE-MD SYNC” appears in the
display.
4
Press ENTER/START.
The MD deck stands by for recording and
the tape deck pauses for play.
Tape playback side
N appears for the front side, and n for
the reverse side. To play the side not
indicated, press TAPE x and remove the
tape to reverse the tape side, then perform
steps 3 and 4 again.
5
Verify that “Press START” flashes in
the display. Then press ENTER/START.
Recording starts.
To stop recording
Press TAPE x or MD x.
Note
If the MD becomes full during recording, the tape
deck and the MD deck stop automatically.
Recording a CD on an MD (continued)