Setting, Power management, Slant setting – Sanyo PLC WTC500L User Manual

Page 57

Setting

Press the SELECT button at
Power management and this
dialog box appears. Use the
Point

7 8

buttons to choose

one of the three options.
Press the Point

button to

select the timer, and then use
the Point

7 8

buttons to set

timer.

Power management

Select one of the following options:
Ready ................. When the lamp has been fully cooled

down, the POWER indicator changes to fast

blinking. In this condition, the projection

lamp can be turned on if the input signal

is reconnected or any button on the top

control or remote control is pressed.

Shut down ......... When the lamp has been fully cooled down,

the power will be turned off.

Off ..................... Power management function is off.

On start

When this function is set to “On,” the projector will be

automatically turned on just by connecting the AC power cord

to a wall outlet.

✔

Note:

• Be sure to turn off the projector properly (see “Turning

Off the Projector” on page 25). If the projector is turned
off in the incorrect sequence, the On start function does
not work properly.

•

When the Standby mode is set to “Eco“ in the Setting, the On
start funcion is disabled. (p.56)

✔

Note:

• Factory default is “Ready: 5 min.”

Slant

This function is used to set the cooling fans’ operation to the

projector’s setting environment. Set this function properly in

accordance with the projector’s installation method. Otherwise,

the cooling fans will not work properly and that causes

malfunctions of the projector and decreases the lamp life.
Select the projector’s installation condition from the following

options:
Off .....When using the projector within the range of the upward/

downward inclination of

70º and +110º~ +180

º,

-110

-180º to the horizontal plane.

L1 ......When using the projector within the range of the upward/

downward inclination of +70º~+110

to the horizontal

plane.

L2 ......When using the projector within the range of the upward/

downward inclination of -70º~ -110

to the horizontal

plane.

L3 ......When using the projector within the range of the upward/

downward inclination of

70º to the horizontal plane

and

the ceiling function is set to “On”.

L4 ......When using the projector within the range of the upward/

downward inclination of +110º~+180

º,

-110

~ -180º to the

horizontal plane and the ceiling function is set to “Off”.

+70°

+110°

-70°

-110°

+180°

-180°

+0°

-0°

“L4” at Ceiling “Off”
“Off” at Ceiling “On”

“L3” at Ceiling “On”
“Off” at Ceiling “Off”

Slant setting