Laser pointer function, Pointer function, Basic operation – Sanyo PLC WTC500L User Manual

Page 32

Spotlight

Pointer Function

Pointer

✔

Note:

• You can choose the size of Spotlight (Large/Middle/

Small) and the pattern of Pointer (Arrow/Finger/Dot)
in the Setting Menu. See “Pointer” on page 55.

This remote control emits a laser beam from the laser light window. Press the LASER button to activate the

laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is

pressed for more than one minute or if it is released, the laser light goes off.

The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself

or other people. The following is the caution label for the laser beam.
CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may

result in hazardous radiation exposure. Never look directly into the laser light window while a laser

is emitted, otherwise eye damage may result.

Laser Light Window

The caution label is put on the remote control.

Signal Emission Indicator

Laser Pointer Function

You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the

projected image.

Press and hold the MENU and SHUTTER buttons for

more than 10 seconds to activate the Pointer function.

(The Laser pointer has switched to the Pointer function.)

Press and hold the MENU
and SHUTTER buttons for
more than 10 seconds.

Press the LASER button on the remote control pointing

toward the projector. The Spotlight or Pointer is

displayed on the screen with the LASER button lighting

green. Then move the Spotlight or Pointer with the

PRESENTATION POINTER button. If the LASER button

does not light green and continues to emit a laser

beam, try the above-mentioned procedure until the

LASER button lights green.

To clear the Spotlight or Pointer out the screen, press

the LASER button pointing toward the projector and see

if the LASER button lighting is turned off.

To switch to the Laser pointer again, press and hold the

SHUTTER and MENU buttons for more than 10 seconds

or slide the RESET/ON/ALL-OFF switch to “RESET” and

then to “ON”.

When you reset the Pointer function, the remote control

code will be reset, as well.

After the Laser pointer has switched to
the Pointer, use the LASER button as
the Pointer function ON-OFF switch.
Press the LASER button pointing
toward the projector and see if it lights
green.

LASER button

PRESENTATION POINTER
button

MENU button

SHUTTER button
RESET/ON/ALL OFF
Switch

Basic Operation