Sanyo PLC WTC500L - Manual (Page 31)

31
Press the P-TIMER button on the remote control. The P-Timer
display “00:00” appears on the screen and the countdown
starts (00:00–59:59).
To stop the countdown, press the P-TIMER button. To cancel
the P-Timer function, press the P-TIMER button again.
P-TIMER button
P-Timer display
✔ Note:
• See the previous page for the
description of other buttons.
Remote Control
SHUTTER
button
P-TIMER
button
Reduce the upper width
with the Point
e button.
Reduce the lower width
with the Point
d button.
KEySTONE button
KEySTONE
button
Basic Operation
SHUTTER button
Press the KEYSTONE button on the remote control. The
“Keystone” appears on the screen.
Use the Point ed7 8 buttons to correct keystone
distortion. The keystone adjustment can be stored
(p.45).
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control again while the Keystone dialog box is being
displayed, the keystone adjustment will be canceled.
• The adjustable range can be limited depending on the
input signal.
• “Keystone” disappears after 10 seconds.
See pages 28 and 58 for details.
Reduce the left part with
Point 7 button.
Reduce the right part with
Point 8 button.
PIP button
Press the PIP button on the remote control to select Picture
in Picture or Picture by Picture mode. See page 52 for
details.
PIP VOL . button
Press the PIP VOL. button on the remote control at the PIP
mode. The volume dialog box appears. Use the Point 7 8
buttons to adjust the volume.
PIP button
PIP VOL .
button