Sanyo PLC WTC500L - Manual (Page 20)

20
Connecting to a Computer (Digital and Analog RGB)
Cables used for connection )( * =Cables are not supplied with this projector.)
• VGA Cable (Mini D-sub 15 pin) (One cable is supplied)*
• HDMI-DVI Cable * • Serial Control Cable *
• BNC Cable * • USB Cable *
HDMI-DVI
cable USB
cable
USB port
USB
Unplug the power cords of both the projector and external
equipment from the AC outlet
before connecting cables.
✔ Notes:
• USB cable connection is needed when operating the
computer with the remote control.
• When the Standby mode is set to “Eco“ in the Setting,
MONITOR OUT and AUDIO OUT are disabled. (p.56)
• See page 84 for ordering optional cables.
Monitor
Output
HDMI
DVI
Output
Monitor Output
BNC
cable
ANALOG
IN
Monitor
Input
G B R H/V V
Installation
MONITOR
OUT
CONTROL
PORT
Serial
Output
VGA
cable VGA
cable
Serial
Control
Cable
✔ Notes:
• When DVI signal is connected to HDMI
terminal with HDMI-DVI cable, connect the
sound signal to AUDIO1
and set up Sound of
"HDMI setup" to "AUDIO1". (p.58)
• This projector can be connected to the
corresponding equipment of DVI however
depending on the equipment there are the
cases it does not operate normally ; the image
does not appear and the sound is not output.