Sanyo PLC WTC500L - Manual (Page 17)

17
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See “Remote control” in the Setting Menu on page 55.
Press and hold the MENU and a number button (1–8)
for more than five seconds to switch between the
codes.
1
To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to “RESET,” and then to “ON.” The
initial code is set to Code 1.
2
Press and hold the MENU and a number button
(1–8) that corresponds to the remote control code
for more than five seconds to switch between
the codes.
MENU button
Remote Control Code
Number buttons
RESET/ON/ALL OFF
Switch
Part Names and Functions
✔ Notes:
• When using as a wired remote control
while the standby mode is set to “Eco”,
the same remote control code should be
set on both the projector and the remote
control to turn on the projector. (p.56)