Connecting to a power source – Samsung WB5500 User Manual
Page 14
013
Connecting to a Power Source
Ê SLB-11A rechargeable battery Specifi cation
Model
SLB-11A
Type Lithium
lon
Capacity 1130mAh
Voltage 3.8V
Charging time
Approximately 200 Minutes
You should use the rechargeable battery SLB-11A supplied with the
camera. Be sure to charge the battery before using the camera.
Ê Number of images and battery life: Using the SLB-11A
Battery life /
Number of images
Conditions
Still image
Approx. 120 MIN /
Approx. 240 shots
Using the fully charged battery,
Default settings, Program mode,
Shot to shot interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the fl ash on every second shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Movie
Approx. 120 MIN
Using the fully charged battery
640x480 image size
30fps frame rate
Ä These fi gures are measured under Samsung’s standard conditions
and shooting conditions and may vary depending on the user’s
methods.
Important information about battery usage.
å When camera is not in use, turn off the power.
å Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
å Low temperatures (below 0°C) can affect the performance of
the battery and you may experience reduced battery life.
å Batteries will usually recover at normal temperatures.
å During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Ŷ Connecting the AC adapter with the USB cable can be used as an
AC cable, and you can charge the rechargeable battery with the
AC cable.
- Using an AC cable:
Connect the AC adapter to the USB
cable. It can be used as a power
cable.
- Using a USB cable:
Remove the AC adapter.
You can download stored images to
your PC (p.108) or supply the power to
your camera through the USB cable.