Sunfire Theater Grand Receiver TGR-401-230 - Manual (Page 9)

User's Manual
9
CHAPTER 1
Manual Setup
There are three main manual ad-
justments that can be made using the
SPEAKERS OSD menu:
1. The SPEAKER SIZE menu al-
lows you to enter the crossover
frequency of each speaker. Using
bass management, any bass
below the crossover frequency will
be redirected to your subwoofer.
2. The LEVEL CALIBRATION menu
allows you to adjust the level of
each speaker until they are all
playing at the same level. (The
level calibration test tones are
also a quick way to check that all
your speakers are working.)
3. The SPEAKER DISTANCE menu
allows you to enter the distance
that each speaker is away from
your listening position. The TGR-
401 then calculates the delay
times.
Details of the manual setup proce-
dure are shown on page 39.
EQ Adjustment
The measurement microphone can
also be used to measure the system
response and adjust the EQ auto-
matically. This will provide a smooth
response and remove room effects.
Alternatively, the EQ of pairs of
speakers, or all speakers can be ad-
justed manually to suit your taste.
Details of the auto-EQ and manual
EQ adjustment are shown on page 41.
OSD Menus
The SPEAKERS menu is used to
run the auto-setup, manual setup, and
EQ adjustment.
1. Press the MENU button on the re-
mote to bring up the MAIN MENU
of the OSD on your TV.
2. Use the navigation pad left, right,
up and down buttons to navigate
through the menus in the next
steps.
NOTE: Quit the OSD at any time
by pressing the nearby EXIT but-
ton. Any changes will be saved.
There is no need to navigate back
through previous pages, unless
you want to make more changes.
The TGR-401 front panel display
shows the same messages as the
OSD.
3. In the MAIN MENU, select
SETUP, and from there select the
SPEAKERS Menu.
4. In the SPEAKERS menu are
the options for AUTO SETUP,
SPEAKER SIZE, DISTANCE,
LEVEL CALIBRATION, and EQ.
5. When you have finished the setup
and/or EQ adjustment, press the
remote’s EXIT button to quit the
OSD.
Conclusion
Once the automatic setup or
manual setup is finished, and any EQ
adjustments made, the TGR-401 is
setup correctly and ready for action.
If you play a Dolby Digital or DTS
encoded source, the TGR-401 will au-
tomatically select the correct surround
mode. If it is a 2-channel source, you
can select a surround mode using the
remote’s MODE buttons or from the
front panel.
The TGR-401 has many more
options that are described in further
detail in this manual. These options
will help you customize the TGR-401
to suit your tastes. You can do this
after you have used the TGR-401
for a while and have a better idea of
how you would like to customize your
system.
Auto Setup (see page 40)
Manual adjustments (see page 39)
Manual or Auto EQ adjustment
(see page 41)
SPEAKERS
AUTO SETUP
SPEAKER SIZE
DISTANCE
LEVEL CALIBRATION
EQ
BINDING POSTS
SETUP
INPUTS
SPEAKERS
VIDEO
MAIN ZONE
ZONE 2
CONTROL
DIGITAL OUT DN MIX/THRU
DIMMER LOW/MEDIUM/HIGH
MAIN MENU
TRIMS
TONE CONTROLS
MODES
PRESETS
SETUP