SVAT Electronics CV501 - 16CH - Manual (Page 30)

30 CV501 - 16CH
To Setup the Relay Time Setup:
1. Select RELAY TIME SETUP from the Alarm Setup Menu.
2. Select
to access the Relay Time Setup Menu.
3. Highlight the type of alarm you want to set up.
4. Use the mouse wheel or directional keys to change the length of time. The 12V signal will be sent to your external alarm when an alarm is
detected.
5. Press Menu or select the
to return to the Main Menu or press the Menu button.
6. Press Menu or select the to exit the Main Menu and save your settings. The DVR may take a few moments to load the settings.
HARD DISK MANAGEMENT SETUP
The DVR comes with a pre installed hard drive. The HDD (Hard Disk
Drive) Management Menu will allow you to display the space left in
the hard drive, clear saved footage and set other HDD related options.
1. Access the Main Menu by pressing Menu or from the Pop Up
Menu Bar.
2. Select the Main Menu icon
.
3. In the Main Menu, select HDD Management .
MAIN MENU...continued
OVERWRITE MODE
The DVR provides you with the option to automatically overwrite the saved video and audio content on the HDD or to stop recording when the HDD
is full. The default setting is ON and will automatically overwrite old footage.
If the mode is set to OFF, you can set a warning to alert you when the HDD is nearing its full capacity. The Capacity Remaining Warning can be set to
5%, 10%, 15%, and 20% remaining. If this option is selected an onscreen message will appear, informing you that your HDD is getting full.
To Set the DVR to Warn You When the HDD is Getting Full:
1. Select OVERWRITE MODE .
2. Use the mouse wheel or directional keys to alternate the overwrite mode between ON and OFF.
3. When you choose OFF a new option will appear allowing you to set a warning level to inform you when the HDD is nearly full.
4. You can choose to set the DVR to warn you that the HDD is getting full when there is :
a) 5% HDD capacity remaining
b) 10% HDD capacity remaining
c) 15% HDD capacity remaining
d) 20% HDD capacity remaining
Use the mouse wheel or directional keys to change the capacity warning amount.
5. Press Menu or select the
to return to the Main Menu.
6. Press Menu or select the to exit the Main Menu and save your settings. The DVR may take a few moments to load the settings.