beautypg.com

Bypass copying – Sharp AR-810 User Manual

Page 98

background image

1

2

3

4

5

6

7

8

9

10

11

12

5-8

USING THE SPECIAL FUNCTIONS

MAX

4. BYPASS COPYING

When you want to make copies on thick paper, OHP film, tab paper, tracing paper, sticker labels, use the
sheet bypass. (Only thick and tab papers can be set in the drawer.

Page 2-7)

If the desired size of paper (standard size) is not set in any of the drawers, or if you want to make copies
on non-standard size, make bypass copies.
The modes below are available even in bypass copying if the paper size is specified:
- automatic magnification selection - duplex

- binding margin

- edge erase

- dual-page

- 2 IN 1 / 4 IN 1

- trimming/masking

- mirror image

- staple sort

- magazine sort

- saddle stitch

- hole punch

In there cases, the setting procedures of the following two sizes of paper are different.
- Bypass copying on standard size

Page 5-10

- Bypass copying on non-standard size

Page5-11

* When copying is finished, the lamp of the //CLEAR ALL key lights. Either press the //CLEAR ALL key

or wait 45 seconds before the bypass copying mode automatically returns to the default mode.

* The copier stops its operation when the paper set on the bypass guide has run out even if there is

the same size of copy paper in the drawer. The copier star ts again when adding the paper on
the bypass guide before the automatic clear all mode works.

Bypass copying

The general procedure for making bypass copies (the paper size is not specified) is described below.

* In this case, the paper exits with its copied side up.

1

Set sheets of paper on the bypass guide and align

the slides with the size of the paper.

Ready for bypass feeding

- This message appears:

- Acceptable paper type for bypass copy

Page 2-4

- Place the paper with the side to be copied facing up.
- If you put several sheets on the bypass guide at a time, fan

the papers well before placing it.

- Place the paper so as not to exceed the line indicated on

the slide.

- Do not push the paper forcibly into the entrance of bypass

feeding. It may cause paper jam.

- Draw the triple paper holder depending on the paper size.

Slide