Sharp AR-810 - Manual (Page 26)

1
2
3
4
5
6
7
8
9
10
11
12
2-2
HOW TO MAKE COPIES
Initial (default) settings
1. GENERAL COPYING PROCEDURES
After placing, or confirming that there is, paper in the drawers, place the originals. When the START key
is pressed with any settings unchanged, copies are made in the initial (default) settings *
1 . You can make
copies as desired by setting different copy modes.
The initial (default) settings of the copier at the time of installation are as shown below.
*1 The copy modes that are automatically set when the power is turned on, when the energy-saving mode is
cleared or when the CLEAR ALL key is pressed on the control panel are called the initial (default) settings.
3 Select the copy modes ( in the illustration on the page on the right) .
- Use the touch panel and the digital keys.
4 Press the START key ( in the illustration on the page on the right) .
- When the reversing automatic document feeder is used and
the continuous feed mode is selected ( Page 5-2), copying begins.
2 Place the original(s).
- Acceptable originals Page 2-9 -When placing an original on the glass Page 2-10
- When using the reversing automatic document feeder Page 2-11
1 Place paper in the drawer(s). -Acceptable copy paper Page 2-4
5 Place the next original (2nd side) and press the
START key.
- Set the first page of your originals first.
- You can also press the YES key before pressing the
START key to perform the same operation.
- Repeat this step for the subsequent originals.
Reproduction ratio. ...100% Copy quantity ......1
Automatic paper selection 1-sided copies from 1-sided originals
Auto image density Standard mode (original image type)
Non-sort Non-staple mode Continuous original feed mode
Copying Procedure
When the desired paper is not placed in any of the drawers or the large capacity feeder :
- Setting the drawer Page 2-6 - Bypass copying Page 5-8
- Selecting multiple copy modes may be restricted depending on their combination.
- Copy modes cannot be changed after the
START key is pressed (including the case
when originals are divided into multiple sets when fed).