Sharp AR-810 - Manual (Page 34)

1
2
3
4
5
6
7
8
9
10
11
12
2-10
HOW TO MAKE COPIES
3. SETTING ORIGINALS (Cont.)
1 Raising the reversing automatic document feeder,
place the original in the direction as shown in the
illustration.
- When using the Book-Type Originals 2-sided Copies (
Page 3-8) or the Dual-Page ( Page 4-5) function, center
the book original on the yellow indicator line.
When Placing an Original on the Glass
Blank sheet
Original
Original
Sheet Originals
1 Raising the reversing automatic document feeder,
place the original face down on the glass.
2 Align the original against the left inner corner of the
glass.
3 Lower the reversing automatic document feeder
slowly.
When using the non sorting and non staple mode, the paper exits face up.
- When copying originals with high transparency, such as OHP
films and tracing paper, place a blank sheet of paper the
size of the original or larger over the original.
Book-type Originals
2 Lower the reversing automatic document feeder
slowly.
- Do not try to force the reversing automatic document feeder
to fully close over a very thick original, such as a big book.
Copies can be made even if the cover or feeder does not
close fully.
- During copying, an intense light may leak out. Do not look
at the original glass surface.