Symbol Technologies DS 3408 - Manual (Page 341)

Standard Default Parameters A-5
Function Key Mapping Disable 8-10
Simulated Caps Lock Disable 8-11
Convert Case No Case Conversion 8-11
IBM 468X/469X Host Parameters
Port Address None Selected 9-5
Convert Unknown to Code 39 Disable 9-6
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface Controller
1
10-5
Leading Margin 80 msec 10-6
Polarity Bar High/Margin Low 10-7
Ignore Unknown Characters Ignore 10-7
Convert All Bar Codes to Code 39 Disable 10-8
Convert Code 39 to Full ASCII Disable 10-9
Undecoded Scanner Emulation
Beep Style Beep on Successful Transmit 11-6
Parameter Pass-Through Parameter Process and Pass Through 11-7
Convert Newer Code Types Convert Newer Code Types 11-7
Module Width 20 µs 11-8
Convert All Bar Codes to Code 39 Do Not Convert to Code 39 11-8
Code 39 Full ASCII Conversion Disable 11-9
Transmission Timeout 3 seconds 11-9
Ignore Unknown Characters Ignore Unknown Characters 11-10
Leading Margin 2 ms 11-11
Check for Decode LED Check for Decode LED 11-12
123Scan Configuration Tool
123Scan Configuration None 1 12-3
Table A-1. Standard Default Parameters Table (Continued)
Parameter
Parameter
Number Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.