Symbol Technologies DS 3408 - Manual (Page 262)

DS 3408 Product Reference Guide 15-30
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 15-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character
Scan the Move Cursor To Character bar code on page 15-31,
then any printable ASCII character from the Alphanumeric
Keyboard . When this is used, the cursor moves to the position
after the matching character. If the character is not there, the rule
fails and ADF tries the next rule.
15-31
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data. 15-31
Move Cursor Past a Character
This parameter moves the cursor past all sequential occurrences
of a selected character. For example, if the selected character is
‘A’, then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move Cursor Past Character bar code on page 15-31, then
select a character from the Alphanumeric Keyboard . If the
character is not there, the cursor does not move (i.e., has no
effect).
15-31
Skip Ahead “N” Characters
Scan one of these bar codes to select the number of positions
ahead to move the cursor. 15-32
Skip Back “N” Characters
Scan one of these bar codes to select the number of positions
back to move the cursor. 15-33
Send Preset Value
Send Values 1 through 6 by scanning the appropriate bar code.
These values must be set using the prefix/suffix values in
Table
7-4 on page 7-21 .
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
15-35