Sony PFV-L10 - Manual (Page 12)

1-6 (E)
PFV-L10
2
MB-862 board
Board guide rails
Component side
Board lever
1
Board lever
1-8. Replacing the Boards
c
Turn off the power of both power supply units and unplug
the power plugs from the outlets before starting the
replacement.
1-8-1. The Plug-in Board
1. Remove the front panel. (Refer to Section 1-2.)
2. Remove the two screws, then remove the board
retainer.
3. Turn the board lever in the direction of the arrow 1,
then pull out the board toward you.
1-8. Replacing the Boards
Connector panel
B 2.6 x 4
Board
retainer
PSW 3 x 6
2. Secure a new connector panel to the PFV-L10 with the
two screws.
4. Turn the board lever of a new board in the direction of
the arrow 2, insert the board along the board guide
rails, then push it until it is securely connected to the
connector on the MB-862 board.
5. Reattach the board retainer and front panel.
1-8-2. The Connector Board
1. Remove the two screws, then remove the connector
panel.