Woodstock M1039 User Manual

Page 16

-14-

D('*0()$Jg\\[;i`ccGi\jj

+% Place the rack inside of the table bracket, mesh it

together with the pinion, and slide the table sup-
port/rack assembly over the column, as shown in
=`^li\((.

,% Slide the column ring over the column with the bev-

eled edge facing down (

=`^li\()), fit the beveled

edge of the column ring over the rack, and tighten
the setscrew.

Efk\1 DXb\jli\k_\iXZb`jj\Xk\[]`idcp`ek_\
cfn\ii`e^Y\]fi\k`^_k\e`e^k_\j\kjZi\n%;fefk
fm\i$k`^_k\ek_\j\kjZi\nfipfldXpjgc`kk_\Zfc$
ldei`e^%

-% Install the crank handle over the pinion shaft, and

tighten the setscrew in the crank handle against the
flat part of the pinion shaft.

.% Thread the handle into the crank handle.

/% Thread the large lock lever into the back of the

table bracket approximately three turns, for now.

0% Thread the small lock lever into the front part of

the table bracket approximately three turns, for
now. The assembly should now be assembled as
shown in

=`^li\(*.

=`^li\((% Sliding table bracket and rack

over column.

=`^li\()% Correct column ring

orientation.

=`^li\(*% Handles and lock levers

installed.

Large Lock

Lever

Crank Handle

Small Lock

Lever