Sharp DV-L70BL - Manual (Page 61)

GB 58
Playing a Disc
1 T 0
2 4 6
MAX MIN
Lower Higher
CAUTION
• Never try to open the disc compartment cover and look inside the disc
compartment at the laser while a disc is playing. Doing so creates the
danger of serious eye damage.
Important!
• Do not press down on the disc compartment cover while a disc is playing.
• Keep the disc compartment cover closed except when loading or
removing a disc. Otherwise, dust getting into the DVD player can lead to
malfunction.
• The indicator appears on the display if the disc you are using is damaged,
if you load the disc upside-down, or if the region number of the disc you are
using is one that is not supported by this disc player. If the above indicator
appears, remove the disc from the player and take the proper corrective action.
Helpful Hints
• Disc scratches, noise, or other factors can cause temporary problems with the
video image from a DVD or video CD. If this happens, press RESUME to jump
ahead to where play returns to normal.
To adjust the volume level
Rotate the volume dial on the right side of the
DVD player to adjust the volume level of the
audio within a range of 0 to 10.
• A safety feature automatically turns off DVD player power if you set the volume
level too high while playing certain types of discs. If this happens, lower the
volume level and restart play.
To stop disc play
1
Press
Ë
STOP.
• If you do not perform any operation for about five minutes after stopping disc
play, indicator disappears from the screen and the DVD player goes into its
Standby mode.
• All buttons except OPERATE are disabled in the Standby mode.
• To restore full power from the Standby mode, slide the main power switch to the
“OFF” position and then back to “ON” again, or press OPERATE .
• You can also restore full power from the Standby mode by pressing RETURN on
the DVD player’s control panel.