Ski-Doo WAKE Series - Manual (Page 91)

MAINTENANCE PROCEDURES
WARNING
Certain components in the engine
compartment may be very hot.
Direct contact may result in skin
burn.
Remove seat(s) to expose cooling sys-
tem expansion tank.
smo2007-002-005_c
TYPICAL
1. Expansion tank
2. Cap
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir when
engine is cold.
F18E0NY
1
1. Level between marks when engine is cold
NOTE: The watercraft is level when
it is in water. When on a trailer, raise
trailer tongue and block in this position
when bumper rail is level.
Add coolant/demineralized water to
have the level between marks as re-
quired. Use a funnel to avoid spillage.
Do not overfill.
NOTE: Use a blend of 50% antifreeze
with 50% demineralized water. Pre-
mixed antifreeze/water is available
(P/N 293 600 038) at your authorized
Sea-Doo dealer.
NOTE: Using a blend of 40% an-
tifreeze with 60% demineralized wa-
ter will improve the cooling efficiency
when watercraft is used in particularly
hot weather and/or hot water condi-
tion.
Properly reinstall and tighten filler cap
then reinstall seat extension.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Sea-Doo dealer.
Engine Coolant Replacement
The coolant replacement should be
performed by an authorized Sea-Doo
dealer.
Throttle Body
Throttle Body Lubrication
Lubricate throttle body with XP-S Lube
or an equivalent.
Use fitting for that purpose provided in
the engine compartment.
With the engine not running, make
sure to spray lubricant at least 3 to 5
seconds for proper lubrication.
smo2008-001-051_a
TYPICAL — GTI MODELS
1. Fitting
_______________
89