Ski-Doo WAKE Series - Manual (Page 120)

MONITORING SYSTEM
A system monitors the electronic com-
ponents of the EMS (engine man-
agement system) and other compo-
nents of the electrical system. When a
fault occurs, it sends visual messages
through the information center and/or
audible signals through a beeper to in-
form you of a particular condition.
When minor faults occur, the fault and
message/beeper will disappear auto-
matically if the condition does not exist
anymore.
Releasing throttle and letting the en-
gine returning at idle speed may allow
normal operation to come back. If it
does not work, try removing and rein-
stalling the DESS key on its post.
The electronic system will react differ-
ently depending on the fault type. In
severe failure, the engine might not be
allowed to be started. In other cases,
the engine will operate in limp home
mode (reduced speed).
When a fault occurs, see an authorized
Sea-Doo dealer as soon as possible for
inspection.
Pilot Lamps and Message
Display Information
The pilot lamps and message display
will inform you of a particular condition
or if an anomaly occurs.
smo2008-001-029_b
TYPICAL
1. Pilot lamps
smo2008-001-026_a
TYPICAL
1. Message display
PILOT
LAMPS (ON)
MESSAGE DISPLAY DESCRIPTION
MAINT Maintenance reminder
(12 V LOW/HI) Low/high battery voltage
FUEL-LOW Low fuel level
H-TEMP (EXHAUST
or ENGINE)
Engine or exhaust system overheating
CHK ENG Check engine
118
______________