Ski-Doo WAKE Series - Manual (Page 48)

CONTROLS/INSTRUMENTS/EQUIPMENTS
6. Adjust trim to the desired position
using VTS buttons.
7. Push both VTS buttons again simul-
taneously to record trim position.
Trim pre-set positions are recorded and
ready to be used.
To record new settings, repeat proce-
dure.
Using Pre-Set Trim Positions
To set trim to the highest trim position
recorded, double-click on VTS upper
button (bow up).
To set trim to the lowest trim position
recorded, double-click on VTS lower
button (bow down).
If trim setting is unique (one position),
double-click either on the lower or up-
per VTS button.
smo2008-001-010_c
DOUBLE-CLICK TO USE PRE-SET
POSITIONS
Shift Lever
A push-pull lever:
– Forward
– Neutral
– Reverse.
WARNING
Shift lever should only be used
when the engine is idling and wa-
tercraft is completely stopped. Do
not use as a grab handle.
WARNING
Only use reverse at slow speed
and for the shortest time possible.
Always ensure the path behind
is clear of objects and persons in-
cluding children playing in shallow
water.
NOTICE Never rev the engine at
high RPM in reverse.
From the forward position, pull the
lever to reverse. Push back to go to
forward. Always set in forward when
finished. To find the neutral, set in re-
verse then push back until the water-
craft stops moving backwards.
Refer to PRINCIPLE OF OPERATION in
OPERATING INSTRUCTIONS section
for the description of the propulsion
system.
smo2008-001-012_a
TYPICAL
1. Shift lever
2. Forward position
3. Neutral position
4. Reverse position
Information Center Gauge
Multifunction gauge that supplies sev-
eral real time useful information to the
driver either in English, French or Span-
ish. See an authorized Sea-Doo dealer
for unit settings.
At start-up, all LCD segments and indi-
cator lights will turn on for 3 seconds
each time the information center is
46
______________