Ski-Doo WAKE Series - Manual (Page 66)

CONTROLS/INSTRUMENTS/EQUIPMENTS
To Empty
NOTE: It is recommended to empty
ballast tanks after each use. Always
completely empty the tanks water
back to the same lake it came from,
do not transfer.
To empty ballast tanks
– Unscrew drain plugs and flush wa-
ter.
– Rinse thoroughly the tanks interior
with fresh tap water.
– When completed, close drain plugs
and tanks valve.
NOTE: It is not necessary to discon-
nect ballast tanks filling hose.
smo2008-001-050_a
TYPICAL
1. Drain plug
WARNING
NEVER tow a watercraft with water
remaining in the ballast tanks. The
weight of ballast tanks increases
the load on the trailer, the axle and
the tires, which could lead to pre-
mature wear or failure. This also
contributes to reduce the stabil-
ity of your vehicle on the road by
raising the center of gravity of the
trailer. Always completely empty
the ballast tanks before trailering.
Removal
Removal procedure is the reverse of
installation, ensure to empty tanks be-
fore removing.
64
______________