Ski-Doo WAKE Series - Manual (Page 47)

CONTROLS/INSTRUMENTS/EQUIPMENTS
smo2008-001-030_a
INFORMATION CENTER GAUGE — VTS
POSITION INDICATOR
1. Position indicator
2. Bow up
3. Bow down
4. Operating range (RXP models)
5. Operating range (other models)
High Performance VTS
RXP-X, RXT-X and WAKE Models
Provides pre-set positions for quick
settings when adjusting watercraft
trim.
Two different trim position can be
recorded, one for each button.
The VTS system will compare trim set-
tings recorded, the highest trim setting
will be assigned to the upper button
(bow up), the lowest to the lower but-
ton (bow down).
If both trim positions are identical, both
buttons will have the same trim set-
tings.
Recording Trim Positions
1. Push both VTS buttons simultane-
ously.
smo2008-001-011_c
TO RECORD
2. PRESET 1 will be displayed in infor-
mation center gauge to indicate that
it is ready to record trim position.
smo2008-001-032_a
PRESET 1 — READY TO RECORD
3. Adjust trim to the desired position
using VTS buttons.
4. Push both VTS buttons again simul-
taneously to record trim position.
5. Then, PRESET 2 will be displayed in
information center gauge to indicate
that it is ready to record another trim
position.
smo2008-001-032_b
PRESET 2 — READY TO RECORD
_______________
45