Sharp SD-CX1H - Manual (Page 58)

58
CX1H_UK49-59.fm 00/12/17
Refere
nc
es
T
roub
le
shoot
ing Cha
rt
Troubleshooting Chart
Many potential "problems" can be resolved by the owner without calling a service
technician.
General
CD player
MiniDisc
Tuner
Remote control
Symptom Possible cause
"TIME ADJUST" appears when the
clock time is checked. Did a power failure occur? Reset the clock.
(Refer to page 17.)
When a button is pressed, the unit
does not respond. Set this unit to the power stand-by mode and
then turn it back on.
No sound is heard. Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires disconnected?
The picture on the TV screen is dis-
torted. When a radio or TV which uses an indoor
aerial is placed near the unit, the picture on
the TV screen may be distorted or the radio
may not function properly.
It is recommended that you use an external
aerial.
Symptom Possible cause
Even though a disc has been loaded,
"CD NO DISC" or "Can't READ" is
displayed. The disc is very dirty.
Is the unit located near excessive vibrations?
Has condensation formed inside the unit?
Playback does not start. The disc is loaded upside down.
Playback stops in the middle or is not
performed properly. The disc does not satisfy the standards.
The disc is distorted or scratched.
Playback sounds are skipped, or
stopped in the middle of a track. Is the unit located near excessive vibrations?
The disc is very dirty.
Has condensation formed inside the unit?
Symptom Possible cause
A recording cannot be made. Is the MiniDisc protected against accidental
erasure?
Did you try to make recording on a playback-
only MiniDisc?
Can you see the "DISC FULL" or "TOC
FULL" message in the display?
Even though a disc has been loaded,
"MD NO DISC" or "Can't READ" is
displayed. The disc is very dirty.
Is the unit located near excessive vibrations?
Playback sounds are skipped. Has condensation formed inside the unit?
Symptom Possible cause
Radio makes unusual noise consec-
utively. The stereo system is placed near the TV or
computer.
FM/AM loop aerial is not placed properly.
Move the AC power lead away from the aer-
ial if located near.
The preset channel cannot be re-
called. Did a power failure occur?
Preset the channel again.
Symptom Possible cause
The remote control does not oper-
ate. Is the AC power lead of the stereo system
plugged in?
The battery polarity is not correct.
The batteries are dead.
Incorrect distance or angle.
Does the remote control sensor receive
strong light?
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)