Sharp SD-CX1H - Manual (Page 55)

55
CX1H_UK49-59.fm 00/12/17
Ad
v
a
nced Fe
atur
es
Enhancing Y
our
St
e
reo Sys
te
m
Listening to the playback sounds from
VCR, DVD, etc.
Recording on a MiniDisc (Sound synchro-
nised recording)
Recording on a MiniDisc (Normal record-
ing)
Headphones
Before plugging in or unplugging the headphones, reduce the volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automatically. Adjust the volume
using the VOLUME buttons.
1
Press the AUX (DEMO) button.
2
Play the connected equipment.
3
Adjust the volume using the VOLUME buttons.
1
Press the AUX (DEMO) button.
2
Load a recordable MiniDisc into the MD compartment, label side
up.
3
Press the S-SYNC REC button on the remote control.
4
Play the connected equipment.
Recording will start automatically.
The recording level is the level adjusted in the previous recording. (This level can
also be adjusted whilst recording.)
1
Press the AUX (DEMO) button.
2
Load a recordable MiniDisc into the MD compartment, label side
up.
3
Press the REC button.
4
Play the connected equipment.
5
Press the or button to adjust the recording level.
Level meter Recording level
Maximum level should not exceed "0dB".
The recording level can be adjusted in 2dB intervals between -4dB and +10dB.
If the recording level is too low, the sound volume will be decreased. If it is too
high, the sound will be distorted.
6
Press the MD button.
0dB -4dB ··· +10dB
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)