Smeg SUK61IPX5 - Manual (Page 9)

Instructions for the user
11
To follow is a table with the minimum diameters of pans according to the cooking zone.
Zone number: Minimum
diameter of the
pan:
It is possible to use pans that are larger than the cooking zones,
ensuring that the bottom of the pan is not coming into contact with the
other cooking zones and that it is still in the middle of the perimeter of
the cooking zone.
1 90 mm
2 110 mm
3 140 mm
4 90 mm
Only pans with a thick and completely flat bottom which are appropriate for induction cooking should
be used, or pans which do not have a rounded bottom (concave or convex).
OK NO NO
8.1.3 Pan presence signal
Each cooking zone is equipped with a device that detects the pan presence and starts off the cooking
only when a suitable pan is present and correctly positioned on the plate.
If the pan is not correctly positioned or is not made from suitable material and one tries to switch on the
plate, a few seconds after the activation of the plate the
symbol indicating an error will appear on the
display.
8.1.4 Residual heat
Each plate is equipped with a device indicating its residual heat. After turning off any of the plates, a
flashing «
» may appear on the display. This signal indicates that this cooking zone is still very hot. It is
possible to begin cooking again even when the is still flashing: in this case, proceed as described in
paragraph «3».
8.1.5 Locking the hob
When switched off, the hob may be «locked» to prevent it from accidentally being switched on by
children.
When the plates are switched off, simultaneously turn the knobs of plates 2 and 3 and then release
them.
The displays of plates 1 and 4 will show the symbol «
» which indicates that the locking of the plates is
active.
In order to unlock them, repeat the same operation: the displays of plates 1 and 4 will show the «
»
symbol, indicating that the locking of the plates has been deactivated.
8.1.6 Heat protection of the electronic card
The appliance is equipped with a device that constantly measures the temperature of the electronic card.
If the temperature goes above a certain value, the device will activate preset functions to lower the
temperature and allow the ceramic hob to continue functioning correctly.
To follow is a table with the operations which are automatically activated with their corresponding starting
temperatures: