Unpacking, Inventory – Southbend South Bend 16 SPEED GEARHEAD LATHE SB1053 User Manual
Page 22
-20-
For Machines Mfg. Since 3/11
16-Speed Gearhead Lathe
P R E P A R A T I O N
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Inventory
Main Inventory 1: (Figure
13
) Qty
A.
Steady Rest Assembly .................................... 1
B.
12" Faceplate w/D1-6 Camlock Stud Set ...... 1
C.
3-Jaw Chuck Key ........................................... 1
D.
Model SB1228 10" Four-Jaw Chuck
w/Combo Jaws ............................................... 1
E.
4-Jaw Chuck Key (Clamped on Lathe) ......... 1
F.
Tool Post T-Wrench (Clamped on Lathe)...... 1
G.
Follow Rest Assembly (Installed) .................. 1
Tool Box Inventory: (Figure
14
) Qty
H.
Tool
Box
.......................................................... 1
I.
Open End Wrench 22/24mm ......................... 1
J.
Open End Wrench 14/17mm ......................... 1
K.
Open End Wrench 10/12mm ......................... 1
L.
Phillips Screwdriver #2 ................................. 1
M.
Standard Screwdriver #2 ............................... 1
N.
Carbide-Tipped Dead Center MT#4 .............. 1
O.
Dead Center MT#4 ......................................... 1
P.
Tapered Spindle Sleeve MT#6-#4 ................. 1
Q.
Carriage Handwheel Handle ......................... 1
R.
Cross Slide Handwheel Handle ..................... 1
S.
Hex Wrench Set 1.5-10mm ............................ 1
T.
Hex Wrench 10mm ........................................ 1
U.
Cast Iron Feet ................................................ 8
Installed & Not Shown
Qty
s
SB1309 9" 3-Jaw Chuck (SB1053) ................ 1
s
SB1310 10" 3-Jaw Chuck (SB1054F-55F) .... 1
Note:
Some inventory components or additional
documentation may be shipped inside of the
lathe electrical cabinet. These items MUST be
removed before connecting the lathe to the power
source.
Figure 13. Main inventory.
A
B
C
D
E
F
G
Figure 14. Toolbox inventory.
Q
L
M
H
J
S
R
T
U
I
K
P
O
N