Sherwood R-865 - Manual (Page 65)

65
Repeat the above steps and until each level is adjusted as desired.
4
• Each time these buttons are pressed, “ ” is moved to
the corresponding LFE level mode.
• Each time these buttons are pressed, the LFE level can be
adjusted within the range of either -10~0 dB for Dolby
Digital program sources or -10~+10 dB for DTS and
MPEG program sources.
• In general, we recommend the LFE level for Dolby
Digital program sources to be set at 0 dB and at +10 dB
for DTS program sources.(However, the recommended
LFE level for some early DTS program sources is 0 dB.)
If the recommended levels seem too high, lower the
setting as necessary.
Press the CURSOR UP( )/DOWN( ) buttons to select the LFE LEVEL TRIM, then press the ENTER
button.
1
Press the CURSOR UP( )/DOWN( ) buttons to select the desired LFE level mode.
2
Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the selected LFE level as desired.
3
When selecting the LFE LEVEL TRIM
L F E L E V E L T R I M
R E T U R N : B a c k , : S e l e c t
D O L B Y - - - - - + 0 dB
D T S - - - - - - - - - - + 10 dB
M P E G - - - - - + - - - - - 0 dB
ENGLISH