Sherwood R-865 - Manual (Page 26)

ENGLISH
26
Erasing all the punch-through functions
programmed under a master device mode
• Then “OK” is displayed and “DELETE” is
displayed.
• To exit from the deleting mode, press any of the
DEVICE buttons.
While “VOL” is displayed, press the
CURSOR UP(
)/DOWN( ) buttons to
select the all punch-through deleting mode
(“DELETE”).
2
Perform the steps and in “Entering a
setup code” procedure on page 19 to select
a master device and the punch-through
mode (“PUNCH”).
1
While “DELETE” is displayed, to erase all
the punch-through functions programmed
under the master device mode, press
ENTER button.
3
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the mode changes as follows:
VOL DELETE PLAY CH
• Then “DELETE” is displayed .
• Then “VOL” is displayed on the LCD screen for
several seconds.
To erase all the punch-through functions
programmed under other master device
mode , repeat the above steps
to .
4