Sherwood R-865 - Manual (Page 42)

ENGLISH
42
RECORDING
• The analog signals from the 8 CH DIRECT inputs as well as the digital signals from DIGITAL inputs can be heard but cannot
be recorded.
• The volume, channel level, tone(bass, treble) settings, etc. have no effect on the recording signals.
Start recoding on the component
connected to TAPE MONITOR.
2
Select the desired input as a recording source
except TAPE MONITOR.
1
Start play on the desired input.
3
• For tape monitor function, refer to “TAPE MONITOR
function” on page 28.
Start recording on the component
connected to VIDEO 1.
2
Select the desired input of VIDEO 2~ 4 as
a recording source except VIDEO 1.
1
Start play on the desired input.
3
or
• The audio and video signals from the desired input will be
dubbed onto the VIDEO 1and you can enjoy them on the
TV set and from the speakers.
• When the VIDEO 2(/ROOM 2) IN/OUT jacks are
connected to video recording component such as video
deck, etc., in the same manner, recording with VIDEO 2
can be performed.
(If this is the case, be sure to deactivate the ROOM 2
function and to set the VIDEO 2 OUT to On. For details,
refer to “When selecting the VIDEO 2 OUT” on page 58.)
Dubbing from video components onto
VIDEO 1
Recording with TAPE MONITOR
Select VIDEO 2 as a image recording
source with performing “When selecting
the CURRENT VIDEO” procedure on
page 57.
2
Select CD as an sound recording source.
Example) When dubbing the VIDEO 2 image signal and
the CD sound signal separately onto VIDEO 1.
1
or
Dubbing the sound and image signals
separately onto VIDEO 1
Image source
Sound source
Image source
Sound source
or