5 displays, Machine state symbols, 6 drawer lock key – Sharp ELECTRONIC CASH REGISTER XE-A201 User Manual
Page 8: 5 displays 6 drawer lock key, Drawer lock key, Displays
6
This key locks and unlocks the drawer. To lock it, turn 90
degrees counterclockwise. To unlock it, turn 90 degrees
clockwise.
Drawer Lock Key
6
Operator display
Customer display (Pop-up type)
Amount:
Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol “-”
appears before the amount.
Number of repeats for repetitive registrations:
The number of repeats is displayed, starting at “2” and incremental with each repeat. When you
have registered ten times, the display will show “0.”(2
→
3 ..... 9
→
0
→
1
→
2 ... )
Receipt function status:
The indicator “_” appears in the RCPT OFF position when the receipt function is in the OFF
status.
Time:
Appears in the far-right six positions (hour-minute -“
” or hour-minute -“
”) in the OP X/Z, REG,
or MGR mode. “
” is displayed in the morning (AM), and “
” in the afternoon (PM). In the REG
or MGR mode, press the
s
key to display the time.
Machine state symbols
:
Appears during programming.
:
Appears when an error is detected.
:
Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.
:
Appears when the
V
key is pressed to calculate a subtotal in foreign currency.
:
Appears when a transaction is finalized by pressing the
A
,
C
or
c
key.
:
Appears when the change due amount is displayed.
: May appear in the far-left three positions at the timing of key entry when the electronic journal (EJ)
memory is full. (Depending on programming.)
:
Appears when the voltage of the installed batteries is under the required level. You must replace with
new ones within two days. Refer to
:
Appears when the batteries are not installed, or the installed batteries are dead. You must replace with
new ones immediately. Refer to
:
May appear right below the eighth and ninth places at the timing of finalization of a transaction when the
electronic journal (EJ) memory is nearly full.
Also appears right below the tenth place when power save mode is effective.
:
Appears when the print head release lever is in the lifted position.
: Appears when the paper is out.
PLU/SUB
DEPT
REPEAT
RCPT
OFF
NUMBER
SHIFT
DC
Clerk code
Displays
5
SK1-1