Sharp ELECTRONIC CASH REGISTER XE-A201 - Manual (Page 10)

8
3. Insert three new “AA” batteries as illustrated at the right.
When the batteries are properly installed “
” on the display will disappear.
4. Close the battery compartment cover.
Be sure to observe precautions shown on page 1 when handling
batteries.
Precaution: The paper cutter is mounted on the printer cover. Take caution when removing and
installing the cover.
The register can print receipts or journals. For the printer, you must install the paper roll provided with the
register, even when you program the register for not printing receipts or journals.
Install the paper roll according to the procedure shown below with the AC cord connected and the mode switch
set to the REG position:
1. Make sure the printer head release lever is positioned as illustrated at the
right.
2. Cut off approximately one revolution of the paper roll. Make sure
the paper end is cut as illustrated at the right.
3. Set the paper in paper roll cradle as illustrated at
the right.
4. Insert the end of the paper into the printer until it is caught by the printer
auto-feed and comes out of the printer at the top. If the printer does not
catch the paper, feed the paper while pressing the
F key.
Correct Incorrect
To the printer
Incorrect
To the printer
Correct
Installing a paper roll 4