Sharp ELECTRONIC CASH REGISTER XE-A201 - Manual (Page 68)

66
When the printed text is getting dark or faint, paper dust may be stuck to the print head. Clean the print head as
follows:
Caution:
• Never touch the print head with a tool or anything hard as it may damage
the head.
• The paper cutter is mounted on the cover. Be careful not to cut yourself.
1.
Turn the mode switch to the OFF position.
2.
Remove the printer cover.
3.
Remove the inner cover that protects the printer. (Press the lever located
both sides and lift the cover up.)
4.
Pull the print head release lever toward you (to the head-up position). (Refer
to the drawing on
page 62 .)
5.
Clean the print head with a cotton swab or soft rag moistened with ethyl
alcohol or isopropyl alcohol.
6.
Return the print head release lever to its original position immediately after
cleaning.
7.
Replace the inner cover. (Insert the side tabs of the cover into their slots and
press the cover in the printer until it is properly seated.)
8.
Reset the paper roll correctly by following the steps in “Installing the paper
roll”.
The drawer in the register is detachable. After closing your business for the
day, remove the drawer. To detach the drawer, pull it forward fully, and
remove it by lifting it up. The 5-denomination coin case is detachable.
The drawer automatically opens. However, when a power failure occurs or the
machine becomes out of order, slide the lever located on the bottom of the
machine in the direction of the arrow. (See the figure at the left.)
The drawer will not open if it is locked with the drawer lock key.
Lever
Opening the Drawer by Hand 9
Removing the Drawer 8
Cleaning the Print Head 7
Coin case
Print head
Roller