Smeg AP361MFEB - Manual (Page 26)

55
Instructions for the Installer
12.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat-
resistant material. Comply with the dimensions shown in figures 1, 2, and
3. When installing under worktops, comply with the dimensions shown in
figure 1-3. When installing under worktops incorporating combined hobs, a
gap of at least 110 mm must be left from any side wall, as shown in figure
1. When installing in tall units, comply with the dimensions shown in figure
1-2, bearing in mind that the top/rear of the unit must have an opening 80-
90 mm deep. Screw the 4 screws A into the inside of the frame (fig. 1). For
installation under tops, make sure that the rear/bottom of the unit has an
opening similar to that shown in figure 1 (ref. B). See the instructions
supplied with the hob for the relative positioning and fixing procedures.