Symbol Technologies LS 1000 - Manual (Page 39)

4-5
LS 1000 Product Reference Guide: Chapter 4, Programming the LS 1004
Scanning Sequence
A scanning sequence establishes a value for one parameter type. During a scanning
sequence, bar codes are scanned to select a parameter. All bar codes necessary for
programming the scanner are provided in the
Appendix section of this manual.
Scanning Sequence Example
In this example, assume you want to program the scanner for all default settings except
for two parameters,
Appendix and Appendix .
Since you want to keep the majority of the default settings, scan the Appendix bar
code. The default for DECODE UPC ONLY is DISABLED, but in this example, you
need it enabled. To do this, scan the DECODE UPC ONLY ENABLE bar code. You’ll
hear hi/lo/hi/low warble. The warble sound indicates that the scanner has been
successfully programmed for the selected parameter. Other beeper indications are
listed in Chapter 3.
The default for INTERCHARACTER DELAY is 0 msec, but you need it set to 2 msec.
To program the scanner for a 2msec intercharacter delay, scan the bar codes listed
below. This sequence includes a two-digit entry; single-digit entries require a leading
zero.
You’ll hear...
1. Scan INTERCHARACTER DELAY Short high tone
2. Scan 0 Short high tone
3. Scan 2 Hi/Lo/Hi/Lo warble
Errors While Scanning
Don’t worry if you make an error during a scanning sequence. If you’re scanning a
multi-step sequence, scanning CANCEL removes you from that sequence so that you
can start again.
Otherwise, simply scan the single correct bar code for the desired parameter.
coverBook Page 5 Monday, December 1, 1997 2:19 PM