Chapter 4. programming the ls 1004, Introduction, Chapter 4 – Symbol Technologies LS 1000 User Manual

Page 35

Text mode
Original mode

4-1

Chapter 4

Programming The LS 1004

Introduction

This chapter provides information on how to program the LS 1004 scanner. Before
programming the scanner, follow the instructions in the

Appendix

section of Chapter

The default table, shown on the following page, illustrates the default values with
which the scanner is shipped. If the default values suit your requirements, scan the

Appendix

barcode. This will set the scanner to the default parameters. Changing the

scanner’s programmable parameters is accomplished by scanning the bar codes
provided in this section.

coverBook Page 1 Monday, December 1, 1997 2:19 PM