Switching cables – Symbol Technologies LS 1000 User Manual
Page 10
1-4
LS 1000 Product Reference Guide: Chapter 1, Introduction and Setup
2.
Twist the cable to the left to lock in place, as shown below:
Switching Cables
Different cables are required for different hosts. To change the scanner cable:
1.
“Unlock” the cable by twisting to the right.
2.
Pull the cable out of the receptacle on the bottom of the scanner.
3.
Insert a new cable in the receptacle.
4.
Twist to the left to lock the new cable in place.
coverBook Page 4 Monday, December 1, 1997 2:19 PM