Symbol Technologies LS 1000 - Manual (Page 34)

3-13
LS 1000 Product Reference Guide: Chapter 3, Maintenance and Specifications
Table 3-5. Beeper Indications
Standard Use
Beeper Sequence Indication
1 Beep - short high tone A bar code symbol was decoded (if decode beeper is
enabled).
4 Beeps - long low tone A transmission error has been detected in a scanned
symbol. The last data scanned was lost. Scan the last
data again.
4 Beeps - short high tone Low power indication; no further scanning is possible.
Change or recharge battery.
3 Beeps - short high tone Power-up (continuous power mode only)
Parameter Menu Scanning
1 Beep - short high tone Appropriate menu within the scanning sequence has
been read
1 Beep - warble sound Parameter value entered successfully
2 Beeps - long low tone Parameter not entered, or incorrect sequence
performed. Scan CANCEL and restart the scanning
sequence.
coverBook Page 13 Monday, December 1, 1997 2:19 PM