SMC Networks Air Weigh AW5800 - Manual (Page 14)

14
BRACKET AND SENSOR INSTALLATION INSTRUCTIONS
Figure 1
Note: Prior to bracket installation, peel off the coating
from the bottom of the bracket assembly (PN 111-0001-
00X).
1. Axle and bracket preparation. Mark the center of the
steer axle (Figure 1).
2. Mark the top of the axle at 2 3/8 inches on either side of
center. Clean the entire 4 3/4 inch wide area inside the
marks with (2) of the supplied alcohol pads (350-0035-000).
You must clean the axle with alcohol before you
start sanding and after you finish sanding for glue
installs.