Samsung SP-F10M - Manual (Page 29)

Installation and Connection 2-14
2-14 Connecting an AV device with Component output
The appearance and the color may differ depending on the model.
Make sure that the AV device and your projector are turned off.
1. Connect the [PC IN] terminal on the back of the projector to the Component terminal on your AV device using a D-Sub to
Component cable (Not supplied). This cable has a D-Sub connector on one end and three RCA jacks on the other.
- For supported input signal formats, resolutions, and frequencies, see AV Timing (D-Sub) in Section 2-8, "Supported Display
Modes".
2. Connect the [ AV IN (L-AUDIO-R) ] terminal on the back of the projector and the Audio out terminal on your AV device using an
audio cable (Not supplied).