Cable system or vhf/uhf antenna system, Cable box, Cable system or vhf/uhf antenna system cable box – Sony GRAND WEGA 2-694-282-13(1) User Manual
Page 20
masterpage:3 columns Right
20
F:\Worker\SONY TROY2 ANA EN 12(1)\2694282121\01US04INS.fm
KF-42/50E200A
2-694-282-12(1)
Cable System or
VHF/UHF Antenna
System
For best results, use this connection if you:
❑
Have a cable or an antenna.
❑
Do not have a cable box or VCR. (If you have a cable box, see below. If
you have a VCR, see pages 25 and 26.)
Cable Box
For best results, use this connection if:
❑
Your cable company scrambles all channels, which requires you to use a
cable box.
❑
You do not have a VCR. (If you have a VCR, see pages 25 and 26.)
To connect the cable box
1
Connect the CATV cable to the cable box’s input jack.
2
Use a coaxial cable to connect the cable box’s output jack to the TV’s
CABLE input.
3
Turn on the cable box first, then run Auto Program as described in
“Setting Up the Channel List” on pages 23.
Notes on Using This Connection
✍
Do not use an indoor antenna, which is especially susceptible to
radio noise.
75-ohm Coaxial cable
Rear of TV
VHF/UHF
CATV cable
Cable box
Coaxial cable
Rear of TV
CABLE
OUT
IN
To do this...
Do This ...
Use the cable box
Tune the TV to the channel the cable box is set to (usually channel 3
or 4) and then use the cable box to switch channels.
Set up the TV remote control to operate the cable
box
Program the remote control. See “Programming the Remote
Control” on page 35.
Activate the remote control to operate the cable
box
Press SAT/CABLE (FUNCTION) once, and the SAT/CABLE
indicator lights up.
Prevent the accidental switching of TV channels When using the cable box, ensure that the TV remains tuned to the
channel that the cable box is set to (usually channel 3 or 4).