Southbend South Bend SB1042PF - Manual (Page 34)

-32-
For Machines Mfg. Since 3/11 Turn-Nado ® EVS Lathes P R E P A R A T I O N
Test Run
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, shut the machine down,
disconnect it from power, and do not operate it
further until you have resolved the problem.
A Troubleshooting section is provided, starting
on Page 88, to assist you with solutions if a
problem occurs or if the lathe does not function
as described in this section.
If you need additional help after reviewing the
troubleshooting section, or you are not confident
troubleshooting the machine on your own,
contact our Tech Support at (360) 734-1540.
To test run your machine:
1. Make sure the master power switch on the
rear of the machine is turned OFF (see
Figure 24).
3. Clear away all tools and objects used during
assembly, lubrication, and preparation.
4. Make sure that the chuck and jaws, if
installed, are secure (refer to Chuck and
Faceplate Mounting on Page 37).
Note: If a chuck is not installed on the lathe, you
do not need to install one for this test.
5. Push the STOP button on the control panel
(see Figure 25), then rotate the spindle
speed dial all the way to the left to set the
spindle speed at the lowest setting.
Figure 24. Location of the master power switch.
Master Power
Switch
2. Read and follow the safety instructions
at the beginning of the manual, take all
required safety precautions, and make sure
all previous preparation steps discussed
in this manual have been followed and
completed.
Figure 25. Control panel.
Spindle
Speed
Dial
Power
Lamp
Coolant
Switch
STOP
Button
6. Turn the coolant pump switch to the OFF
position, and point the coolant nozzle into
the chip pan.