Sharp SD-AS10 - Manual (Page 17)

17
SD-AS10
Preparation f
o
r U
s
e
- S
y
stem connec
ti
o
n
s
/ Antenna
conn
e
c
tion -
" Connecting the system connection cable
Connect the main unit and amplifier unit as follows.
Antenna connection
Installing the AM loop antenna:
Outdoor FM or AM antenna:
Use an outdoor FM or AM antenna if you require better reception. Consult your
dealer.
When using an outdoor AM antenna, be sure to keep the wire of the AM loop antenna
connected.
1
2
Amplifier unit
Main unit
Arrow
Screw
Push
Unplug
1
2
To connect:
The plug is directional.
Connect it with the arrow
facing toward the screw.
To disconnect:
Pull the plug straight out
pressing the plug.
How to open side cover
Open the side cover to connect the system.
System
connection cable
Supplied FM antenna:
Connect the FM antenna wire to the FM 75
OHMS jack and position the FM antenna wire in
the direction where the strongest signal can be
received.
Supplied AM loop antenna:
Connect the AM loop antenna wire to the AM
and GND terminals. Position the AM loop anten-
na for optimum reception. Place the AM loop an-
tenna on a shelf, etc., or attach it to a stand or a
wall with screws (not supplied).
Note:
Placing the antenna on the unit or near the AC
power cord may cause noise pickup. Place the
antenna away from the unit for better reception.
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
White
Black
FM antenna AM loop antenna
Amplifier unit
Outdoor FM antenna
Outdoor AM antenna
49 feet (15 m)
25 feet (7.5 m)
AM loop
antenna
Ground wire Ground rod