Sony RM-NX7000 - Manual (Page 51)

51
Basic Oper
ations
■ When the component to be registered does not function properly
The selected preset code may be incorrect. Select again the preset code by
pressing the [v] or [V] key, aim the Remote Commander at the component
to be registered, and then press the [TEST] key again. Repeat this operation
until the component to be registered functions properly.
■ When the component to be registered functions properly
The correct remote control signal was transmitted. Go to step 4.
4 Press the [OK] key.
The preset code is programmed for the Remote Commander and the
display returns to the component selection display (step 3 on page 43).
z Tip
If you press the [CANCEL] key, the preset code will not be programmed and the
display will return to step 1 on page 50.
5 To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.