Sony RM-NX7000 - Manual (Page 48)

48
Continued
Programming the preset codes of components (PRESET)
Programming a preset code using the list of brand preset
codes (BRAND)
The following steps are continued from step 4 on page 44.
Programming a preset code of a TV component is explained here.
1 Press the [BRAND] key in the
programming method
selection display.
Instructions for the preparation of the
component to be registered appear in the
display. Set the component to the status
as instructed.
2 Press the [OK] key.
The list of brand names and preset codes
appear in the display.
3 Press the [v] or [V] key to
select the brand of the
component by the cursor,
aim the Remote Commander
at the component to be
registered, and then press
the [TEST] key.
The Remote Commander transmits the remote control signal. If there are
two or more preset codes for a brand, select the first one and press the
[TEST] key.
■ When the component to be registered functions properly
The correct remote control signal was transmitted. Go to step 4.